Dodge Ram 5th Gen Reaper Bedside Decals - Grim Reaper Rear Bed Graphics Kit

Precision Fit: Our decals, stripes, and graphic kits are engineered for an exact fit and superior finish. Each design is tailored to its intended placement, ensuring the visual flow follows factory body lines correctly. We sell only what we personally install so fitment is proven, not assumed.

Exclusive Designs: We create and offer original decal designs available only through us. Every vinyl graphics kit is custom cut per order, ensuring freshness, accuracy, and no mass stocked inventory.

Continuously Evolving: Our product lineup is constantly refined and expanded. If you don’t see a design that matches your vision, contact us custom solutions are always welcome.

Installer Friendly: While professional installation is recommended for complex kits, all of our products are designed with the installer in mind, making application as straightforward and stress free as possible.

At dealership parts departments, graphics kits often cost between $600-$900, come in limited color options, and offer no customization. We deliver factory quality premium vinyl graphics at highly competitive prices giving you full control to personalize your decals with your choice of colors or color combinations from our extensive selection.

Vinyl Decal Installation Guide (Wet Method)

Our decals are precision cut for an exact fit. For best results, we recommend
the wet installation method, which allows easy positioning
and bubble free application.

Tools Required

• Spray bottle (water)
• Plastic squeegee (felt edge recommended)
• Masking tape
• Microfiber towel
• Isopropyl alcohol (70% or higher)
• Sharp blade or utility knife

Step 1: Surface Preparation

Wash the application area thoroughly with soap and water. Dry completely.
Clean the surface using isopropyl alcohol to remove wax, grease, or residue.
The surface must be clean, smooth, and cool to the touch.

Step 2: Test Fit & Positioning

Without removing the backing paper, place the decal on the vehicle to check
alignment. Use masking tape to hold it in position and create reference points.

Step 3: Prepare the Wet Solution

Fill a spray bottle with clean water.

Step 4: Apply the Decal

Peel the backing paper off the decal slowly. Lightly spray the adhesive side
of the decal and the vehicle surface. Place the decal onto the vehicle; it
will slide for easy adjustment.

Step 5: Alignment & Squeegee

Adjust the decal into its final position. Starting from the center, squeegee
outward using firm, even strokes to remove all water and air bubbles.

Step 6: Remove Transfer Tape

Allow the decal to set for 10–15 minutes. Slowly peel the transfer tape back
at a sharp angle (180°). If vinyl lifts, press it back down and squeegee again.

Step 7: Final Trimming

If the decal crosses door seams, panel gaps, or edges, carefully trim using
a sharp blade. Press edges firmly to ensure proper adhesion.

Step 8: Curing Time

Do not wash the vehicle for 24-48 hours. Avoid pressure washing, extreme heat,
or high speed driving during the curing period.

Important Installation Tips

• Ideal installation temperature: 15°C-30°C (60°F-85°F)
• Avoid installation in direct sunlight or on hot panels
• Take your time proper alignment ensures the best finish