Vinyl Decal Installation Guide (Wet Method)
Our decals are precision cut for an exact fit. For best results, we recommend the wet installation method, which allows easy positioning and bubble free application.
Tools Required
- Spray bottle (water)
- Plastic squeegee (felt edge recommended)
- Masking tape
- Microfiber towel
- Isopropyl alcohol (70% or higher)
- Sharp blade or utility knife
Step 1: Surface Preparation
Wash the application area thoroughly with soap and water. Dry completely. Clean the surface using isopropyl alcohol to remove wax, grease, or residue. The surface must be clean, smooth, and cool to the touch.
Step 2: Test Fit & Positioning
Without removing the backing paper, place the decal on the vehicle to check alignment. Use masking tape to hold it in position and create reference points.
Step 3: Prepare the Wet Solution
Fill a spray bottle with clean water and add only 2-3 drops of dish soap. Do not over soap. Shake gently.
Step 4: Apply the Decal
Peel the backing paper off the decal slowly. Lightly spray the adhesive side of the decal and the vehicle surface. Place the decal onto the vehicle; it will slide for easy adjustment.
Step 5: Alignment & Squeegee
Adjust the decal into its final position. Starting from the center, squeegee outward using firm, even strokes to remove all water and air bubbles.
Step 6: Remove Transfer Tape
Allow the decal to set for 10-15 minutes. Slowly peel the transfer tape back at a sharp angle (180°). If vinyl lifts, press it back down and squeegee again.
Step 7: Final Trimming
If the decal crosses door seams, panel gaps, or edges, carefully trim using a sharp blade. Press edges firmly to ensure proper adhesion.
Step 8: Curing Time
Do not wash the vehicle for 24-48 hours. Avoid pressure washing, extreme heat, or high speed driving during the curing period.
Important Installation Tips
- Ideal installation temperature: 15°C-30°C (60°F-85°F)
- Avoid installation in direct sunlight or on hot panels
- Take your time proper alignment ensures the best finish